Better Wilcom Docs Site

Appearance

Use runs as connectors ​

ObjectProperties00007.pngUse Docker > Object Properties to toggle the Object Properties docker on/off. Use it to set runs as connectors.

You can use runs of single stitches to connect objects in a design. Because runs cannot be trimmed, they are visible on the final embroidery, unless another object is digitized to cover them.

connectors00008.png

To use runs as connectors... ​

  1. Click the Object Properties icon and select the Connectors tab.

connectors00009.png

  1. Select a connector method:
OptionFunction
After objectAllows you to adjust settings of connectors immediately following the current object.
Inside objectAllows you to adjust settings of connectors joining letters within a lettering object, and motifs within motif runs. This setting also applies to disconnected parts of branched objects. It does not apply to segments within an object.

  1. Select Run and enter a length for the connecting run stitches.

  2. Adjust Tie In settings as required. The Tie Off and Trim After options are disabled as they do not apply to travel runs.